DC pump mods for/with profilux

[The Codfather]

Just looking at it, Id say they are very close to comparison.
I have the WP40 completed and running, so a few things need to be figured out.
More to come. Again, please lets keep the thread a clean one.
Thanks for looking,
Bob

[The Codfather]

Consider this board cut in half.
The right hand side-110v
The left hand side-low voltage.
Right hand side.-Power comes in, splits to feed both AC/DC adapters.
Upper left-to profilux
Lower left-1-10v signals(or in the case of wp40 1-5v)

[The Codfather]

Here is a quick reference for the wiring.



You can read it directly from the board.

[The Codfather]

I just placed everything in a PVC box to keep it clean and neat.



So what you see here is the completed box.
The four connections that you see on the sides are:
1-110v power coming in.
2+3-110v power out-to AC/DC adapter
4-cable to profilux

The top of the box has the two plugs from the AC/DC adapters, and the three prong that attaches to the pumps. The harness is just inside the casing.

[The Codfather]

Hooked up and mounted to under side of tank. I chose to run the two adapters externally because of the heat generated by them.

[The Codfather]

Here is a few screen shots, if your familiar with the profilux, this was actually the easiest set up.
Set up 1-5 volt signal in 1-10v interface


In current pumps, assign pump numbers and program.

[The Codfather]

Now that everyone is caught up, let's get started on the waveline.

With the controller open we can again identify the wires.





Again, two wires coming in off the AC/DC adapter, a positive and a negative.
Labeled as M+ and M- on the board.
Also three wires going to the pump,
Labeled 24+, 24-, and VA.