Tank Broken or Not

[Ross]

Originally Posted by globaldesigns

I would say it depends on how much glass is left with the sealed surface.

I myself had a corner chip off my tank when it was first moved in, almost 5 years ago. It was the very back corner, not large, more of a corner flaked off. I put some crazy glue on it, to seal it and to make it smooth. To this day I have never had an issue, and one would probably never know it was there.

In your case, your damage looks a bit more than what I had, so again, it would depend on what is left for glass. If there isn't much left over the actual seal, I probably wouldn't take the chance. Not sure if what I see is a big chunk sitting on the table surface or if you are asking about the chip I see above the black tape, or both.

That's not tape, that's the chunk that is missing and is on the table.

Personally I wouldn't risk it.
You could reinforce the corner with a section of glass inside the tank, but that would require a reseal job.

[Borderjumper]

I would file a claim with your insurance for a new tank.. If that was a top corner I wouldn't worry too much, but being at the bottom the whole tank will drain if it leaks.

[micah]

I think that is what I will have to do. Thanks for the advise. Yes, that is the large piece of glass that come off.

[FishyFishy!]

Very mixed opinions here, however I think with a chip that has no visible cracks, and all seems to be terminated, I think you'll be fine. I have a sump with a chunk missing from the corner and it's been fine for 3 years.

What I did was thouroughly examined the area with a magnifying glass to make sure that there was no residual cracks as a result of the chip (any tiny cracks could easily run when filled and result in a large leaking crack). I then filled the chip with silicone using an acrylic corner square to make it look nice and flush. You can barely notice it's even there.

I would risk it if there are no cracks. However that being said.... if you can get a brand spankin new tank from your insurance company... then do it! lol.

[micah]

Is it possible to get 2 pieces of glass and then use some kind of glass glue to reinforce this corner from the inside? I would then use aquarium silicone to reseal this corner.

Thoughts?

[globaldesigns]

Originally Posted by Ross

That's not tape, that's the chunk that is missing and is on the table.

Personally I wouldn't risk it.
You could reinforce the corner with a section of glass inside the tank, but that would require a reseal job.

Thanks, knowing that I wouldn't risk it.