![]() |
#11
|
|||||
|
|||||
![]() |
#12
|
|||||
|
|||||
![]() Reef crest at 80% for me. I just wish it wasn't so damn loud!
|
#13
|
||||
|
||||
![]() I have one running reef crest at 100% along with 2 Koralia 1050's.
|
#14
|
|||||
|
|||||
![]() Had 2 on my 55 <36x18x21> thought there was lots of flow till I bought a mp40 to hold while replacing a dunked control. mp40 is a little strong for the some of my corals to be right in front of but an inch or 2 out of the stream is ok. mp10 left mp10 back mp 40 right. 10's at 100% 40 at 80ish. I switch between tidal swell and nutrient uptake once every while.
to bad the 10s wont fit on the next build 2 new 40s is going to add to the cost ![]() happy with them other than that. |
#15
|
||||
|
||||
![]() I have one mp10w es and is on short pulse mode,running at 50% to minimize the noise,supplemented with two koralia 750.
|
#16
|
||||
|
||||
![]() I have 2 on opposing sides of a 40 breeder and use Reef crest and Nutrient transport modes.
|
#17
|
||||
|
||||
![]() I have four MP10s running, two on each side. Two opposing sides are running reef crest on anti-synch. Other two are on tidal or nutrient uptake.
|
#18
|
||||
|
||||
![]() Running 3 100 percent on reef crest mode. One on back glass and two on either end of the tank
|