Wavy Sea help

[Delphinus]

I wrapped a ridiculous amount of teflon tape around mine to make a snug fit.

Rather annoying that it's not a standard snug fit .. maybe it's a metric thing. Metric fittings aren't real easy to source, though.

Good luck....

[The Codfather]

Originally Posted by Delphinus

I wrapped a ridiculous amount of teflon tape around mine to make a snug fit.

Rather annoying that it's not a standard snug fit .. maybe it's a metric thing. Metric fittings aren't real easy to source, though.

Good luck....

You bet.
Its metric.
I can see what I have at home, how much do you need?

[Reefer Rob]

You can actually shrink PVC down by heating it in an oven until its soft, I think 200 F would do it, then GENTLY tighten a hose clamp around it while its in place. Remove the hose clamp after it cools, and if you didn't tighten the hose clamp too much it will be a tight slide fit.

[Werbo]

I only need to extend the outlet 1-2 inches..

I will try Robs trick with the oven... now to figure out how to use an oven
Maybe the bbq will work

[The Codfather]

Originally Posted by Tyler Werbowski

I only need to extend the outlet 1-2 inches..

I will try Robs trick with the oven... now to figure out how to use an oven
Maybe the bbq will work

Do not expose it to direct flame, you will not get the desired result.

[Werbo]

At Lordco Auto they had a variety of different o-rings in both diameter and thickness. I found something that I think will work. Won't know until I put 1000gph through the WS outlet.

Thanks for the help