VDM and tunze 6055 setup

[Aquattro]

Here is my left side 6055

Set AM-Left
If Time 08:00 to 13:30 Then AM-Left
If Time 13:30 to 21:00 Then Day-Lft
If Time 21:01 to 23:59 Then PM-Left
If Time 00:01 to 07:59 Then AM-Left
If FeedA 000 Then OFF

Then you name different profiles after the Then = stuff, like PF1 is called AM-Left, etc. No virtual outlets, just times to run profiles.

Profile is -
Synchronize Enabled Divide by 10 Disabled Initial off time (0 Seconds) On time (8 Seconds) Off time 6 (Seconds) Minimum intensity 30 Maximum intensity 75 Then just change up the Day and PM profiles to run what you want. Or just use a single profile for now.

[windcoast reefs]

Thanks ill give that a try, I think my cable that I borrowed may be broken, that's my only guess as to why it's not working now

[Aquattro]

If you unplug the cable to the VDM they should be on 100%..right?

[windcoast reefs]

Originally Posted by Aquattro

If you unplug the cable to the VDM they should be on 100%..right?

Yup, but when they are plugged in they just pulse every 30 seconds for 1 second. Can't manually turn them off, they just pulse. Then I unplug it and they go back to 100%, another project for after work I guess!

[Aquattro]

Originally Posted by windcoast reefs

Yup, but when they are plugged in they just pulse every 30 seconds for 1 second. Can't manually turn them off, they just pulse. Then I unplug it and they go back to 100%, another project for after work I guess!

Mine do that in feed mode, not sure why, I haven't looked at it yet. But that tells me the outlet isn't firing properly. Likely just a syntax error..

[windcoast reefs]

Originally Posted by Aquattro

Mine do that in feed mode, not sure why, I haven't looked at it yet. But that tells me the outlet isn't firing properly. Likely just a syntax error..

Okay I'll post my code after work and see if that's the problem.

[Aquattro]

Also, if you have them plugged into the power bar, make sure the outlets are turned on.

[windcoast reefs]

Originally Posted by Aquattro

Also, if you have them plugged into the power bar, make sure the outlets are turned on.

Yup the outlets are on, tested them with a lamp. Just ordered another cable, needed it anyways for another set of pumps. Then I can narrow down the problem