![]() |
|
#1
|
|||||
|
|||||
![]() ok, so today not a single coral has normal polyp extension. Last night after the flatworms started dying, I put several pounds of pure carbon in the filter sock and let it run for a few hours. Before bed I changed that sock (It smelled to high heaven), and since I didn't have anymore straight up carbon left, I dumped a container of Pura Complete into the filter sock.
I haven't been running a phosphate absorbing media in my tank for the past couple of months, so I'm not sure now if the polyps are reacting to residual toxin from the flatworms, or if they've been shocked by a sudden drop in phosphate levels. I've removed the pura complete and have done a 20% water change, and I'm not seeing any improvement. Anyone have any ideas? |
#2
|
|||||
|
|||||
![]() Flatworms are toxic when they die, believe it or not you have to remove them once you kill them with exit. In the end the common flatworm is harmless, I'll never treat for them as they usually come back anyway. Control is the best solution with a wrasse or something that eats them. Huge water change at this point is your best option.
|
#3
|
|||||
|
|||||
![]() I'd say 98% of them got sucked up in the overflows and taken out with the filter sock. By the time I went to bed, there weren't any more bodies left in the water or visible on the rock.
I also filtered with carbon for almost an entire day. I guess my real question is whether or not a sudden drop in phosphate levels will cause polyps to close up, because if not, I need to do a whole bunch more water changes. |
#4
|
|||||
|
|||||
![]() When I used flatworm exit, I just ran carbon, and I didn't notice any problems like that, so perhaps it is an issue with the phosphate (that being said, I have only zoas and acans in that tank)
|
#5
|
||||
|
||||
![]() You're better off with water changes over carbon. Using massive quantities of carbon can stress your corals out just as much as a million dying flatworms.
Now, given that it's too late to siphon out visible flatworms PRIOR to using the product, here are some guidelines to casualty free Flatworm Exit use: - moderate carbon use - frequent, medium (20%ish) water changes - insane flow - emptying your skimmer cup every time you walk by the tank That's about it. As long as you follow those through, you'll be fine ![]()
__________________
This and that. |
#6
|
||||
|
||||
![]() Quote:
it sure can a sudden drop in phos is also bad
__________________
........ |
#7
|
|||||
|
|||||
![]() Well everyone was back to normal today, so I guess whatever it was it was just temporary.
Gonna do another water change tonight just to be sure, and I started running GFO again in my reactor. I figure if they'd already freaked out from a drop in phos, it would be better to let them adapt to the lower level and keep it that way! |
#8
|
|||||
|
|||||
![]() Just thought i should add that the acans colony that ate the most of the flatworms when I dosed is officially toast. I'd say maybe 3 of it's heads are still reasonably intact, the rest only have little bits of tissue left clinging to the skeleton. The open brains and the other acans colony are fine though, as are the rest of my corals.
|