My stupid re-silicone questions!

[Coasting]

Heres one of each corner.

[Aquattro]

They stick those on pretty good, eh? Ya, if it's that stuck, don't risk breaking the tank.

[Coasting]

Is it easier to pull off fresh silicone then old silicone? like 12 hours old?

I'm livid! I trusted my father to help me silicone the tank and he made the biggest mess possible! Not only did he not listen to a single thing I said in regards to how thick and where but he starts going over it again with his fat fingers making a mess after its starting to set! "Oh you wont see it" Its a tank am I never going to look at it once its full or something?

I think its fully sealed but it looks like crap in the back 2 seams! He didn't even give me a chance to tape the back corners. Theres disgusting smears and finger prints coming out more then an inch from the corners. Is it easier to just pull it all off again and re do it? (seriously ready to pay one of you guys to do this, cash in hand!)

I'm going see how bad of a mess it looks in the morning and if I can simply use a blade to fix this up or if I should spend the next week ripping this silicone off to re-do it. Oh hey and the kicker... for some reason he assumed I wanted the top black brace futher siliconed to the tank so he starts running a bead along the edge to the black brace so now I will never get the top corners cleaned up.....

Just had to vent, couldn't sleep, too angry about the tank.

[MKLKT]

You can see why I was hesitant to suggest re-silconing. It's likely easier to peel it when it's cured as you can get a continuous strip; otherwise, if it's not cured it may still be an irritant as well as kinda smear instead of coming off. (Over night is probably enough.) At least you've got dry weather for the near future if it's outside. You could easily razor off the fingerprints or smears but don't mess with the edges.

At least you know that brace isn't going anywhere.

[Coasting]

I didn't want to have to, but once I started cleaning out the insides and actually crawled inside to scrub the overflow, i noticed theres wasn't much left of the old silicone in some places. Just didn't feel comfortable with how it looked. Thats a lot of water on the floor and crabby people I would have to deal with if it sprung a leak....

I just wish if people didn't want to help, and they wanted nothing to do with my fish, they would go away and not touch my projects.

I'm going to attempt to razor away the nasty figer smears and see how it looks. At least I got the tape in the 2 front corners. And if It still looks like crap, guess I get to go buy more blades and start over again. 2 tubes of silicone left, whats that 2 more trys?