Beckett holders

[StirCrazy]

Originally Posted by IslandReefer

Looks slick Steve.
Did you cut a groove for your big O-ring, or just squeeze it?
Also did you modify the beckett any on the bottom, ie to put O-rings or is that just friction fit too?
And are you going to make use guess the final prize winning dimensions?
I'll have to follow the next few steps, close to assembly time?
BTW beauty edges!

the big O'ring just sits inside the screws so they locate it. The becket is friction fit top and bottom.

Originally Posted by Jack

Would be nice with keyhole and thumbscrews eh?

you buy me the 300.00 rotery table and I will put the Keyholes in as for thumb screws thats what I was looking for but Home Depot didn't have any.

Steve