Sugar Sand, Aragamax Select, Or Larger?

[blacknife]

I like the look of sand, the owner of my last tank had 1" + Crushed coral in there without any problem but after I dumped some sugarfine in it started getting the stank spots. I think I might try a bag of seafloor grade in this setup before I upgrade to whatever my next setup is.

This tank started out with some sugar fine but with some of the flow i ended up with bare spots. I have sucked out most of the sugar fine leaving a shallow sand area over 1/3 - half the tank and a rubble zone in the other half. ZnP are in the rubble zone and I pull an occasional natural spreading frag out of there.

I tried bare bottom in my frag tank and the bottom cracked.. although i do not believe the crack was related to the bare bottom, there was no rock-slide that i could see i just came downstairs and the tank was cracked.

[Jaws]

Is the Caribsea Seaflor sand too large for sand sifting fish?

[Jaws]

Originally Posted by Jaws

Is the Caribsea Seaflor sand too large for sand sifting fish?

Can anyone comment on this?

[daplatapus]

Originally Posted by Jaws

Can anyone comment on this?

I've got Caribsea flor in both my 20 gal cube and my 77 gal display. My yellow watchman goby and pistol shrimp sift through it all day long in my cube and I have a twinspot goby that sifts through it in my main DT. They don't seem to mind. From what I've read anything 1-2 mm is good.

[Madreefer]

2"-3" sugar sand in 144G with 2 MP40's and a MP10. I used to have a little bit of sandstorms but with some playing around with the positioning of some rocks and the vortechs it's no longer a problem. And no dead spots.

[Spyd]

It all boils down to whether or not you are running a shallow sand bed (less than 2") or deep sand bed (4-6"). For a SSB, you want more coarse sand that you can siphon if necessary. The Seaflor is great for this and allows sand sifting fish to accept it.

For a deep sand bed, you want to use Sugar size or oolite sand. You do not want any sand sifting fish in this setup. Some Nassarius snails are great in this case to mix up the top layer of sand. It does settle down when the bacteria colonizes and weighs it down. Still, in a high flow area, it will have a tendancy to blow around.

I ran a DSB in my 75G with very good results. Only problem is my 75 is fairly heavy stocked and ended up with some Red Slime. It is very hard to siphon anything out without making a mess. So, with my new 180G setup, I went with 2" of Seaflor Select so siphoning can easily be done if necessary and be able to keep some sand sifters. I also have a remote DSB plumbed into my system to use the benefits of that and if any problems arise with it, I can easily take it offline and not have any ill affects on my display tank.

[Enigma]

Originally Posted by daplatapus

I've got Caribsea flor in both my 20 gal cube and my 77 gal display. My yellow watchman goby and pistol shrimp sift through it all day long in my cube and I have a twinspot goby that sifts through it in my main DT. They don't seem to mind. From what I've read anything 1-2 mm is good.

My twin spot was the reason I went with a finer sand in my display tank. I was worried about the coarseness of the Aragamax Select. It is the 1-2mm stuff that I've got, and it is just so coarse. If yours can handle it, maybe I'll think about swapping it out. I do have some sand in the water column.

[sphelps]

Originally Posted by Jaws

Is the Caribsea Seaflor sand too large for sand sifting fish?

That's what I've always used and I've always kept sand-sifters.