Radions...ready to throw out the window

[cale262]

They're pretty easy to program....er, once you've done it. I hada similar issue whe I first received mine, it was a very simple solution to the point of almost being embarrassing but still I was getting increasingly frustrated, I simply did not click on the group to be programmed...

I'm assuming you have, but did you watch the programming video. If that doesn't help, set them back to factory setting.

[Coralgurl]

I know they should be easy to program..... I've reset to factory and started from scratch to see if this will set the way I want. I don't need to play with these, just trying get some consistency. I've gone through the video and manual....if this doesn't work will go to ecotech for help.
Thanks

[reefbyremote]

Another hint is to first plug in the usb without the ecotech software running. Then start the software. I had issues if I didn't do it in that order.

[Nano]

I say toss em and get SOLs jk

[subman]

I am having issues with one of mine as well and I sent an email to ecotech and have to say their service is incredible. Give it a shot.

[Coralgurl]

Originally Posted by subman

I am having issues with one of mine as well and I sent an email to ecotech and have to say their service is incredible. Give it a shot.

I was out tonight when the lights shut down, will see what happens tomorrow with the programming.

I plug the USB in and have to click on the ecotech link to get it going so that's not a problem.

If this continues with the random lighting I will follow up with ecotech.

[Coralgurl]

Originally Posted by Nano

I say toss em and get SOLs jk

Nope, not going to debate lights, just a bit frustrated...

[mexxedm]

1. Unplug the power. Important step.
2. Plug in USB to computer.
3. Reset it.
4. Reprogram or use natural mode.
5. Set the time.
6. Program it.
7. Unplug USB.
8. Wait for 3 mins.
9. Plug the power in.
10. Try it again.
Mine went dead. Yes, completely dead. These steps worked for me.

[reefgirl189]

I had the same problem. Turns out that after programming you need to switch modes. Press and hold the cycle button (middle button). This will switch modes for you and you should hopefully find that it switches from pre programmed modes to your new finely tuned one. Hope that makes sense.