![]() |
#1
|
|||||
|
|||||
![]() Fin-Omenal Fish (the LFS near my house) was looking for a invert holder that could be hung on the side of the tank, and since I mentioned I've started some acrylic projects, they asked if I could make them one.
I was just going to make a real basic one, but since I had a little time, I went a little... overboard ![]() Instead of putting holes for the waterflow, I went with the design from my tank cover, and put small waves on the front, 2 sides, and the 3 inside walls. The wave slots are 1/16". The 2 hangers are also adjustable in height by 2". This is a shot without the insides. I made them removable incase they ended up getting a bigger invert, or more of one type, and wanted to keep them in a bigger holding area. And yes, the color is different for the middle wall. I ran out of acrylic, so I used some leftover polycarbonate. Bigger Pictures Here Obviously a picture of it in the tank would help. I'll take one next week. |
#2
|
|||||
|
|||||
![]() Nice job!
__________________
Brad |
#3
|
||||
|
||||
![]() Superb craftsmanship. Did you cnc it or cut it with a saw?
Did you say it was bullet resistant? ![]()
__________________
John its all about quality, not quantity..... ...when in doubt buy a Binford.... |
#4
|
|||||
|
|||||
![]() Quote:
built resistant? |
#5
|
||||
|
||||
![]() Very nice work!
__________________
Joel. Notice how reef rhymes with thief? I guess both rob you of your valuables. |
#6
|
|||||
|
|||||
![]() Quote:
|