![]() |
|
#1
|
|||||
|
|||||
![]() Shelley made up her mind, trouble is hubby isn't going along with it -lol
__________________
Brad |
#2
|
|||||
|
|||||
![]() Shelley, do you need a little help from us ????
We could always start some kind of riot or something ![]() Honestly, I wish we could show your hubby what it's like with weird backgrounds and such ![]() |
#3
|
|||||
|
|||||
![]() The new LR is leaching too much NO3 and PO4 to go in the DT system now
Looks like I'll have to do some WCs and be patient while it cooks some more ![]() On the plus side, the snails and herms are doing a nice job of keeping the DT fairly clean I've been messing with the MP10 settings and placement and am happy so far with the detritus situation |
#4
|
|||||
|
|||||
![]() Quote:
Quote:
I think it a bit unwise that he leave us (our three-year-old and myself) to our own devices on a weekend. I've purchased the paint already. He hasn't noticed it sitting there, yet. Quote:
|
#5
|
|||||
|
|||||
![]() Our 2 x MP10wES are centered about 30% from the front ( to center )
I had them about 25% down from the top ( to center ), and that was great for surface agitation, but not for detritus settling Currently they are about 40% down I set a mild wave ( less than 1/2" total travel ) in Short Pulse and am now running them in Nutrient Transport Mode @ 80% ( 10 of 12 LEDs ) This gives me a wave with about 1/4" travel So far so good If you do decide on a pair, you'd be able to turn them down low enough in that tank that I doubt you'd hear them Last edited by gregzz4; 05-28-2012 at 10:24 PM. |
#6
|
|||||
|
|||||
![]() Wow! I'm surprised you have them cranked up to 80%. That's 1260 gph for each pump (unless the change is logaritmic . . . which it might be). 1260x2/75=33.6 . . . so that's 33.6 times the tank volume per hour. 20 is recommended for SPS. Does that mean that the flow seems quite gentle?
|
#7
|
|||||
|
|||||
![]() It may seem like a lot of flow if you look at it that way. I'm sure I'll have to change things once I start adding softies and LPS
I'm only basing my settings right now on the amount of snail poop that settles on the sand ![]() Until you make your mind up about buying some, you could ask around if someone would let you see their's running They way mine are set right now, they pulse left - right - left - right It's about a 3/4 second pulse each side, back and forth. This creates the wave. On the setting I'm currently using, they run this way for about 1/2hr or so, then there's a big surge. It's supposed to mix everything up and then flush it out the overflow BTW, every tank is different, so where you start off with them placement-wise is up to you I just raised mine back up closer to the top by about an inch as I didn't like the dust that was collecting on the surface in some areas I'm still going to have to fool around with them until I'm happy |