Squire's 90 Gallon Build, Now With Salt Water

[gregzz4]

Originally Posted by ensquire

Issue #3) Sump flow

I wouldn't be so concerned about all the drain water going through your skimmer
If you sat down and calculated what it takes to cycle your whole tank through your skimmer, you'd agree
Keep your return water flow where you want it. 5 - 6 times or so per hour is fine.
My 75g, with 110g total water, flows about 650gph. I've been told that's lots, otherwise the socks and skimmer can't do their job effectively

The rest of your flow happens inside your tank

If you're thinking about 15-20gph flow, that's the total of everything with a full-blown SPS tank, not what runs through your sump, and not what a new tank needs

You and I only need about 10 times per hour to start with, give or take

[The Grizz]

When the tank is running Mike, where is the water level inside the OF box? From my experience with the durso the top of the Tee where it meets the 90 should be just below the bottom of the teeth on the overflow and your water level should be about the halfway mark on the tee to 90 section. I also cut down the top of the tee as short as possible and have cut the 90 end facing down shorter as well.

[ensquire]

Originally Posted by The Grizz

When the tank is running Mike, where is the water level inside the OF box? From my experience with the durso the top of the Tee where it meets the 90 should be just below the bottom of the teeth on the overflow and your water level should be about the halfway mark on the tee to 90 section. I also cut down the top of the tee as short as possible and have cut the 90 end facing down shorter as well.

When the tank is running the water in the overflow is maybe a half inch below the teeth, so 3/4" below tank water level. the Tee / 90 intersection is at almost that same height, 1/2 to 3/4" below teeth.
I will mod the Tee and 90 and see where that takes me.
Thank you ol' Mighty King of the Durso.