Brs dual reactor....gfo not tumbling

[Cal_stir]

Are the threads leaking or the tubing?

[Cal_stir]

If you are running the dual, are you running carbon in the other reactor?, the carbon side could be plugged.
If you are running the cobalt maxi-jet pump, check the impellar, the vanes break off.

[Coralgurl]

The treads and connections, not the tubing.

[Cal_stir]

You need to teflon tape the threads

[subman]

Chrck the foams and the carbon section, if they are plugged it will cause a lpt of back pressure and strain the joints.

[Coralgurl]

Yes there's carbon in the other chamber. I will pull it all out and make sure nothing is plugged up. I have tape as well, if that helps, will give it a try. Thanks for the help!

[gregzz4]

I'm sure you are already aware, but, just in case ...
If you decide to change some media while you have it apart, don't do both at the same time

[Coralgurl]

Well the carbon was a block, so I dumped it, cleaned the foam pads, refilled and everything is working again. Did not change the gfo. I run a canister filter on myl other tank so I know not to change everything at once. I still need to add tape but not sure where the bf put it and he's still at work....

Another question, how often do the pads need to be changed out?

The help is much appreciated!

[subman]

It depends how much debris you have floating around, I check them monthly and rinse when needed.