|
|
|
|
|
#1
05-09-2012, 04:38 AM
|
|||||
|
|||||
Well now the skimmer is working
 The little clear spinner washer was installed on top of the plate, instead of underneath. Either the manufacturer, or the member I bought it used from, put it above the plate and it wouldn't close the door enough Maybe it worked for the member with his sump level .... Anyway, I'm finally getting some NOG and can start dialing it in  BTW, all that's in there is the base rock, so I guess 'tis dirty   
|
|
#2
05-09-2012, 06:12 AM
|
||||
|
||||
|
Love that skimmer
__________________
150DD mix reef with 90 gal sump and 40gal frag tank purple tang, sohal tang, yellow eye kole tang, fairy wrasse. cleaner wrasse, leopard wrasse, and misc fish. GHL Mitras 6200HV X 2, MP40 X 2, MP60 X 1, tunze 6095 X 2, Vertex RX6 calcium reactor, Bubble King SM250, Aquamaxx bio pellets reactor, Profilux 3
|
|
#3
05-09-2012, 06:29 AM
|
|||||
|
|||||
|
Quote:
I'm just learning how to use it
|
|
#4
05-09-2012, 06:31 AM
|
|||||
|
|||||
|
This is not the scaping plan
Just evidence that the LR is finally in  
|
|
#6
05-09-2012, 07:03 AM
|
|||||
|
|||||
|
Quote:
LR cured for 3 months in the dark I lost all the mini brittle stars, don't see the mini hermit and don't see any amphipods anymore Still have a couple mini clams and a small snail Can't wait to add stuff !! SG 1.026 pH 8.14 NO3 0.00 +/- PO4 0.00 +/- No other testing yet ... no point 
|
|
#7
05-11-2012, 09:46 AM
|
|||||
|
|||||
|
I finally got around to setting up this Tunze ATO 3155
I gotta tell ya, when I first walked away from it, I thought it was all good. I tested it by pulling water out with a jug, and then putting it back, and all was great. I went to the kitchen and started a conversation with the wife .... Not long after, the Hi alarm went off and we thought it was something on the TV  I ran to the sump room and, after viewing the problem, I unplugged the power supply to the ATO. It had already dumped 1 gallon of RO into the sump !!!!!!!!! I then spent the next, say, 2 hours, setting it up and I think it's all good now. So, problem solved, at least overnight, and we'll deal with it tomorrow I had to add some salt and remove some water ...... My problem, I think, was the chaeto tank. For those of you that haven't been following along, it's above the sump on a separate pump. I watched when the chaeto tank level raised, and, of course, the sump level dropped. I never thought this would be enough to upset the ATO, but it did. The trick was to set the ATO to ignore all this, yet still work properly I ended up having to set the Optical sensor much higher than originally planned. It is now very close to the HI level float. Seems to work so far ... 3 hrs running and no stupid cycling I cannot post a good pic as the location of the mounts is tight Useless pic .....  Last edited by gregzz4; 05-11-2012 at 09:49 AM.
|
Hybrid Mode
