|
|
|
|
|
#1
05-06-2012, 04:12 AM
|
|||||
|
|||||
This I have done. The heaters are 1-2 degrees +/- hotter, but I still want to either ...
A - have the temp probe in the overflow box and the switch turn off the heaters in the sump B - put the probe in the sump's heater chamber 
|
|
#2
05-06-2012, 04:16 AM
|
|||||
|
|||||
|
If I put the probe in the heater chamber, I need to re-configure some stuff and hope the Temp probe wire is long enough.
I used the suction cup for something else  I have a spare suction cup for the probe 'cause I bought spare probes ( redundancy ) so I can do that if that's the best way to go. So, should I bail on all this fancy programming and just put the danged probe in the sump's heater chamber ?
|
|
#4
05-06-2012, 04:28 AM
|
|||||
|
|||||
|
Quote:
I was hoping to probe the water before all the plumbing, but I guess it doesn't make that much difference, does it ?
|
|
#5
05-06-2012, 04:46 AM
|
||||
|
||||
|
You can go to this forum to get help or email them directly, you get an answer in less than 24 hrs.
http://www.forum.digitalaquatics.com...?f=26&start=25
|
|
#6
05-06-2012, 04:48 AM
|
|||||
|
|||||
|
Thanks Casey
If I have to, I will contact DA I've read through all their forum info, but some of it is still useless. This case is a prime example where reefme showed me something not clarified on the DA site
|
|
#7
05-06-2012, 04:53 AM
|
||||
|
||||
|
Quote:
That was why I just email them and get an answer promptly and accurately what I want because I don't have patience like you 
|
|
#8
05-06-2012, 04:27 AM
|
|||||
|
|||||
|
Well, unless there are some wonderful ideas about programming a switch to turn off my heaters, I guess I'm going to put my $30 probe holder in the sump's heater chamber
At least it can also hold the Ranco probe What a waste of money
|
Hybrid Mode
