ATO issue.... maybe

[Nate]

Pump output must be above the highest level the water can be in the resevoir. So water may have to fall 2 feet into sump.

What I usually do on these installs is plumb in a much larger line, like 1 inch pvc from the bottom of the stand to just above my water level in the sump. And then just run my pump line into the top of the PVC (close to the stand) and let it run through there down into the sump so you don't have water free falling 2 feet. Due to the line being bigger, that helps with your syphon stop.

Nate

[paddyob]

Originally Posted by Nate

Pump output must be above the highest level the water can be in the resevoir. So water may have to fall 2 feet into sump.

What I usually do on these installs is plumb in a much larger line, like 1 inch pvc from the bottom of the stand to just above my water level in the sump. And then just run my pump line into the top of the PVC (close to the stand) and let it run through there down into the sump so you don't have water free falling 2 feet. Due to the line being bigger, that helps with your syphon stop.

Nate

I just discovered this on another site. Was considering it. Might go this route.

[paddyob]

I have some of the grey PVC lying around. Is this able to be used in this application? I think I will try the larger PVC and just let the pump hose drain to this.

I used white (potable) for my tank... just not sure if the grey has some property that is undesirable.

[Mandosh]

It'll either be Sc80 or electirical conduit; both will be fine.

[paddyob]

Originally Posted by Mandosh

It'll either be Sc80 or electirical conduit; both will be fine.

I believe it was the electrical stuff.

So nothing to worry about in regards to contamination of my water?

[paddyob]

Originally Posted by Nate

Pump output must be above the highest level the water can be in the resevoir. So water may have to fall 2 feet into sump.

What I usually do on these installs is plumb in a much larger line, like 1 inch pvc from the bottom of the stand to just above my water level in the sump. And then just run my pump line into the top of the PVC (close to the stand) and let it run through there down into the sump so you don't have water free falling 2 feet. Due to the line being bigger, that helps with your syphon stop.

Nate

This worked like a charm. Had all the parts needed to zip something together.

Thanks!

[tim the toolman]

I had to do the same lol. Glad it's workin for yah.

[paddyob]

Originally Posted by tim the toolman

I had to do the same lol. Glad it's workin for yah.

The real test will be seen when I get home... First real top up happens sometime this aft... While I'm at work.

[tim the toolman]

And........how did you make out today?

[gregzz4]

Ya, c'mon, how'd it go?