I made a simple hanging system for two SOL.. I got a eight foot pce of 3/4" aluminum tubing from Home Depot, it was $15.99, cut in half for the two rails. They have balck plastic plugs for the ends to finish it a bit nicer. I drilled a hole through the tubing for the rail screws on the fixture. Then I drilled a 1/2" hole on the top side of the tubing so the screwhead is inside of the tubing rather than on the top side of the tubing. I bought a AI hanging kit that was un-useable in my situation but used the two end cables that were to attach to the ends of the AI rail system and attached them to the inside sides to the tubing and hung the light with them. Cutting and assembly was about twenty minutes
Last edited by jorjef; 02-20-2012 at 09:48 PM.
|
02-20-2012, 09:39 PM
Hybrid Mode
