RO question/advice

[Junmity]

is 2 or 3 ppm acceptable for aquarium setup?

[tim the toolman]

It's not that bad, I doubt even those running ro di are changing filters at 2ppm but if your not goin to shoot for 0 ppm 13 ppm out of the tap isn't really that extreme either.

[Junmity]

Really, 13 ppm is the same as 2ppm?

i'm setting up a 120g so waiting for the stuff to produce is a PITA...

if that's the case would you recommend that the juice is not worth the squeeze?

[tim the toolman]

I am not nearly as knowledgeable as others on here but it seems others are holding off on commenting. Put it in perspective, my tap water is over 100ppm so I use ro/di. But at 13ppm I personally would just fill the tank and add prime to remove the chlorine and chloramine and then just let the tank cycle as you should anyways. Then for you top offs once the tank is up and running it may be worth the ro but 13ppm seems very low. Again this is just my opinion.

[tim the toolman]

Just tested a cup of tap water and it came in at 162ppm.

[Junmity]

I already have 30g produced so i think i'll continue to use the 2ppm....

it cant hurt and the extra time i leave it mixing with the salt will probably be good for it....

[tim the toolman]

Do you plan to not let the tank cycle or some time?

[Junmity]

Yes,

I'm transferring the contents of my 30 gallon tank which also has cured rock.

i just meant that i have a 30 g mixing tank and the day it takes to produce another 30 g of ro gives my first batch more time to mix....

i already put new live sand in the 90 so i'm mixing my salt then adding it to the 90 g slowly.

i plan on moving half the rock over and then letting it cycle.