![]() |
|
#1
|
|||||
|
|||||
![]() Yes I have always ran fresh air line in the winter to my intake line for air for the skimmer... helps alot.
__________________
180 starfire front, LPS, millipora Doesn't matter how much you have been reading until you take the plunge. You don't know as much as you think. |
#2
|
|||||
|
|||||
![]() my pH has been up a bit too. I installed an HRV this winter got me thing here the fresh air in the room now could be doing it too.
__________________
CAD 22 brent |
#3
|
|||||
|
|||||
![]() "The pH of marine aquarium water is intimately tied to the amount of carbon dioxide dissolved in the water. It is also tied to the alkalinity. In fact, if water is fully aerated (that is, it is in full equilibrium with normal air) then the pH is exactly determined by the carbonate alkalinity The higher the alkalinity, the higher the pH, and equilibrated with air having extra carbon dioxide as might be present in a home (1000 ppm). Clearly, the pH is lower at any given alkalinity when the carbon dioxide is raised. It is this excess carbon dioxide that leads to most low pH problems for reef aquarists"
That was a quote from one of Randy Holmes articles. With fresh o2 in the house it could affect the ph in our aquarium , also if your refugium has seen good growth over the last bit, it could also take up amount of co2 in the tank and by reducing co2 level we know it will also raise ph. Just food for thought.
__________________
Though a tree grow ever so high, the falling leaves return to the root. 300DD - 140DD ![]() TOTM Fall 2013 |
#4
|
|||||
|
|||||
![]() According to my Ph probe my tank is sitting @ 9.09.
__________________
Feed the bear goodies, make a new friend, don't feed the bear............... 8' - 165gal Reef DIY LED's Build 2012 Nano Contest Winner Febuary 2013 POTM Winner 300 gal + 60 gal Complete DIY Build |
#5
|
|||||
|
|||||
![]() When my Halides turned on my PH would always go up .2 or more after i moved my controller to the new location. Moved some cords around, and made it spike up .5 when the halides where on.
Make sure you're not running the wire near ANYTHING electrical. They gain 0.41mV per PH, so having electrical wires around them can easily change that. Just mentioning in case you've moved some wires around recently that could be causing it. It's most likely the increased O2, lots of people have summer/winter PH levels because of more windows being open.
__________________
My 150 In Wall Build |
#6
|
|||||
|
|||||
![]() Probe needed re-calibrating. Thanks everyone.
__________________
![]() 314 gallon Drop Off Reef tank. 150 gallon sump. Bean Animal Overflow. Various Tangs, Angels, Triggers, Inverts, Corals, etc. http://www.canreef.com/vbulletin/showthread.php?t=80379 |
#7
|
|||||
|
|||||
![]() Still goes up. Not as much but still going up.
When I re-calibrated the probe it went to 8.13. Down from 8.37. All yesterday it was at 8.19. This morning when the lights came on it was 8.22. I have my RO/DI unit set to run for 30 mins per day to top off the water. Nitrates and Ammonia are 0. PH test verified probe reading. Sump gets lots of bubbles from overflow.
__________________
![]() 314 gallon Drop Off Reef tank. 150 gallon sump. Bean Animal Overflow. Various Tangs, Angels, Triggers, Inverts, Corals, etc. http://www.canreef.com/vbulletin/showthread.php?t=80379 |