![]() |
|
#1
|
|||||
|
|||||
![]() The tank is in the office/dining room, no doors. I covered the floor around the tank but didn't notice the dust till I went to bed. Had the window open but still gave everyone headaches....
![]() Here's a question...to look at the tank, I can't see through it, but when a light is held behind it, I can a bit. Will this matter when the lights are hung? |
#3
|
|||||
|
|||||
![]() Perfect, thanks Brett!
|
#4
|
|||||
|
|||||
![]() Plumbing started yesterday, few issues (main overflow into sump too short, emergency drain too long). Otherwise, thoughts?
![]() ![]() ![]() ![]() ![]() ![]() |
#5
|
|||||
|
|||||
![]() Not sure if anyone noticed this or commented, but no foam under the tank? Is there a reason? I thought it was always recommended in order to remove possible stress points. Same would go for the sump also, if there is no foam.
__________________
![]() Setup: 180G DT, 105G Refuge (approx. 300lbs LR, 150lbs Aragonite) Hardware: Super Reef Octopus SSS-3000, Tunze ATO, Mag 18 return, 2x MP40W, 2X Koralia 4's Wavemaker Lighting: 5ft Hamilton Belize Sun (2x250W MH, 2X80W T5HO) Type of Aquarium: mixed reef (SPS & LPS) with fish Dosing: Mg, Ca, Alk |
#6
|
|||||
|
|||||
![]() Depends on how the black plastic trim is. If its flush to the bottom, then I would say yes. If it has that gap underneath, then no.
|
#7
|
|||||
|
|||||
![]() Yeah I think her base is trimmed in Plastic.
|