![]() |
#1
|
|||||
|
|||||
![]() Hi all,
I got a new sump for Xmas, and now I need some advice on how to get my old one out and the new one in. Got the aqueon model 3...nice looking sump which I intend to do a refuguim in. So here is the problem, my existing glass sump is in a wood and glass cabinet under my 90 gal tank. There is a main support 3" support in the middle outside edge that the sump is tight against. The only way to get that support out is to undo bolts on top and bottom of stand...so that is out of the question. Any advice? Any help from someone local who could help? Really appreciated, Steve'o |
#2
|
|||||
|
|||||
![]() So if you can't get the old sump out, what advice are you looking for?
![]() |
#3
|
|||||
|
|||||
![]() Don't want to do that...afraid I will do so much damage.
Was thinking I could take the front glass off the existing sump by removing the silicon, not sure how to do this? Steve |
#4
|
|||||
|
|||||
![]() If you plan on putting the new in the same place you will have no choice but to remove the center support to get it in anyways.
|
#5
|
|||||
|
|||||
![]() Is your stand a 2x4 construction? DIY or store bought? if it's 2x4 you could reinforce it by putting beefing up the lateral beams with a couple extra 2x4's. You may be able to do this to a store bought as well, then you should be able to remove the centre beam. IT all depends on what's on the sides for support, and also if you'll be able to get any reinforcement in there.
__________________
My 150 In Wall Build |
#6
|
|||||
|
|||||
![]() A picture of your stand would help people give suggestions on a plan of action. Pictures do tell 1000 words.
![]() |
#7
|
|||||
|
|||||
![]() Great reason to get another tank.
![]() |
#8
|
|||||
|
|||||
![]() Quote:
Steve |
#9
|
|||||
|
|||||
![]() Quote:
Steve'o |
#10
|
|||||
|
|||||
![]() Good point, but would have to sell this one first.. as I would want it in the same place. Would not mind a bigger tank... hmmmmm ![]() Steve'o |