![]() |
|
#1
|
|||||
|
|||||
![]() ya screw the pail and run a line from your RO unit to the top off line its so easy PM me your number and I will explain it hustler
__________________
180 starfire front, LPS, millipora Doesn't matter how much you have been reading until you take the plunge. You don't know as much as you think. |
#2
|
|||||
|
|||||
![]() Quote:
With this option, he'd need to have a controller hooked to a solenoid on the RO/DI input, and then run it directly to the tank. |
#3
|
|||||
|
|||||
![]() Mike, you're nuts to hook the top off straight to the RO/DI system. If there is ever a failure all of a sudden your fish are swimming in freshwater! I know two people that have crashed their tanks this way. Imo, not a good idea.
Hustler, I use a 5 gallon pail for my 90 and it is a bit small for in the summer when evaporation is at its peak. I think you're looking for something close to 30-40 gallons or so if you have room. Running the line through a wall into an adjacent room is pretty simple. You could install it to run behind the baseboards if you want. Make sure the end of the top off line (the end at the tank/sump) is higher than the water level of the vessel you are pumping from otherwise it will gravity feed out of the vessel. ![]() |
#4
|
||||
|
||||
![]() I would'nt go the direct RO/DI conect either it has other problems other then stated already such as the membraine leaching which is not to critical when making large quantities each cycle but to stop start a unit all day every day is well just bad,
Also agreed that a large brute can or the like will make you very happy when you dont have to make up sml 5gl buckets all day sundays ![]() Be carfull I did this and brought a cheapO storage bin. I was out of town for 8weeks and had me misses look after the refilling of the bin , long story short I came back to a half dead SPS tank and could not find any problems until I decided to remove the Bin from service ( last thing I changed in tank) and at the bottom of the bin it was like milk. The Bin had leached, hell knows what I put into the tank. |
#5
|
|||||
|
|||||
![]() Mel, we have a 16G cylindrical tub made out of polyethylene that might work for you at the shop...come on down and check it out if you'd like.
__________________
32"x32"x20" Cube-ish tank |
#6
|
||||
|
||||
![]() I use a salt pail with a gamma lid. (snaps onto a 5 gallon pail with a screw on lid top.)
However if you use it without the ring that snaps to the pail top, there's just enough room for the lid to sit flush and let the cable/tube come out. |
#7
|
|||||
|
|||||
![]() I haven't had a system running yet, but would never run RO/DI direct.
It isn't efficient this way and can obviously dilute your system if it fails. I am lucky that I have a room where I can store 55g if need, although I will probably never hold that much at one time. I just bought a drum/barrel http://www.canreef.com/vbulletin/showthread.php?t=80884 Sorry if the add doesn't apply to your area ![]() My plan is to have a 10g top-up for my 100g system. No direct plumbing. trudge the water to my ATO as needed. |