|
|
|
|
|
#1
10-14-2011, 04:23 AM
|
|||||
|
|||||
PG Plastics here in Prince George sells several diameters of acrylic rod.
__________________
"We shall dive down through black abysses... and in that lair of the Deep Ones we shall dwell amidst wonder and glory forever." - H.P. Lovecraft Old 120gal Tank Journal New 225gal Tank Journal May 2010 TOTM The 10th Annual Prince George Reef Tank Tour 
|
|
#3
10-14-2011, 05:30 AM
|
||||
|
||||
|
Rods
I think I might try to get some from IPP in Kelowna this weekend. I did consider swiping the plastic rod used for adjusting blinds and using that, but I wasn't sure how much I could trust it.
I was thinking about getting 3/8" rods. Is the idea I would just drill a 3/8" hole about an inch deep in both rocks and cut the rod to the appropriate length and stick em together? I'm trying to build two columns and then build some supports for a shelf as well. Thanks
|
|
#5
10-16-2011, 06:31 AM
|
||||
|
||||
|
Got Rods
I drove to Kelowna this morning and picked up about 14 feet of 3/8" acrylic rod and a small sheet of acrylic from IPP. The rods were super cheap but the acrylic sheet on the other hand was a bit pricy. Tomorrow I'm going to attempt to build some towers. I'll post some pics of the process and the results.
Chad
|
|
#6
10-22-2011, 04:12 AM
|
||||
|
||||
|
Aquascape
So here is what I came up with. I had some problems with the large shelf piece as it was too heavy. I ended up having to use 5/8" PVC inserted into a piece of acrylic with a 5/8" hole drilled in it. I then glued the PVC to the acrylic sheet. Also, I drilled 5/8" holes through a heavy rock to use as the base and through all the small rocks and threaded them on until they were almost all the way to the top. I drilled a shallow 5/8" hole in the shelf and placed it on. I then used some epoxy to level the bottom rock so it would not wobble and used epoxy to steady the shelf piece.
For the small tower on the right I drilled a 3/8" hole in the bottom of the rock and placed it on a 3/8" acrylic rod connected to a piece of acrylic. I then drilled a 3/8" hole in the top of the rock and the bottom of the larger rock. I then just stuck them together using a 3/8" rod. I still need to use some epoxy to stabilize the bottom rock.  Chad
|
|
#7
10-30-2011, 07:07 PM
|
||||
|
||||
|
i have a bunch left over from when I did my build, pm me if you need some
|
Hybrid Mode
