|
|
|
|
|
#1
10-13-2011, 07:50 PM
|
|||||
|
|||||
If there was an Industrial Paints and Plastics somewhat near you they'd have some. If I have no idea if they have a presence in the Interior of BC but you can check their website for a map of their franchises. http://ippnet.com/
In a pinch, fibreglass rods might work just as well as acrylic (may even be stronger) and might even be easier to find. Look for snow markers meant to mark out parking lots and driways and sidewalks and such - Canadian Tire, Princess Auto, Home Depot and other similar places should carry them.
__________________
-- Tony My next hobby will be flooding my basement while repeatedly banging my head against a brick wall and tearing up $100 bills. Whee! 
|
|
#3
10-14-2011, 12:48 AM
|
|||||
|
|||||
|
I got mine from IPP in Langley/Surrey. I wonder if they could mail some to you?
|
|
#4
10-14-2011, 02:28 AM
|
||||
|
||||
|
get those plastic curtain rods...
__________________
150DD mix reef with 90 gal sump and 40gal frag tank purple tang, sohal tang, yellow eye kole tang, fairy wrasse. cleaner wrasse, leopard wrasse, and misc fish. GHL Mitras 6200HV X 2, MP40 X 2, MP60 X 1, tunze 6095 X 2, Vertex RX6 calcium reactor, Bubble King SM250, Aquamaxx bio pellets reactor, Profilux 3
|
|
#5
10-14-2011, 03:58 AM
|
||||
|
||||
|
The fiberglass rods are great. Less flex and quite a bit stronger.
__________________
72 gal bowfromt mixed reef sps dominated, 25 gal mineral mud type sump/refugium Skimmerless 2x250 14000k phoenix hqi 2x96 pc actinic, 50x flow
|
|
#6
10-14-2011, 04:23 AM
|
|||||
|
|||||
|
PG Plastics here in Prince George sells several diameters of acrylic rod.
__________________
"We shall dive down through black abysses... and in that lair of the Deep Ones we shall dwell amidst wonder and glory forever." - H.P. Lovecraft Old 120gal Tank Journal New 225gal Tank Journal May 2010 TOTM The 10th Annual Prince George Reef Tank Tour
|
|
#8
10-14-2011, 05:30 AM
|
||||
|
||||
|
Rods
I think I might try to get some from IPP in Kelowna this weekend. I did consider swiping the plastic rod used for adjusting blinds and using that, but I wasn't sure how much I could trust it.
I was thinking about getting 3/8" rods. Is the idea I would just drill a 3/8" hole about an inch deep in both rocks and cut the rod to the appropriate length and stick em together? I'm trying to build two columns and then build some supports for a shelf as well. Thanks
|
|
#10
10-16-2011, 06:31 AM
|
||||
|
||||
|
Got Rods
I drove to Kelowna this morning and picked up about 14 feet of 3/8" acrylic rod and a small sheet of acrylic from IPP. The rods were super cheap but the acrylic sheet on the other hand was a bit pricy. Tomorrow I'm going to attempt to build some towers. I'll post some pics of the process and the results.
Chad
|
Hybrid Mode
