|
|
|
|
|
#1
09-13-2011, 06:10 PM
|
||||
|
||||
I have never found a 20g with 3/8" glass... Most are 5-6mm, which is easy to cut. Cutting glass flat is easy but when its fixed completeing the run is the hard part and you will run into issues in the corners
33 stiches from a chainsaw isnt that bad mindy  I get that count from plate glass and windshield slips...
|
|
#2
09-13-2011, 06:20 PM
|
|||||
|
|||||
|
Whoops! I meant 3/16".
 Ya, I'm worried about scribing because I know it won't break nice if I can't do it in one smooth scribe and one smooth move to do the breaking. I don't think I can do it. I wish I had a junker tank I could try it on. If attempted to scribe I was going to scribe a short end first from the outside, then try to break into the inside. That way I could get a good scribe, but not sure how to do a good break to the inside.Oh I know...I am freakin lucky with the chainsaw.
|
|
#3
09-13-2011, 06:26 PM
|
||||
|
||||
|
The break doesnt have to be one smooth break. There are more then 1 way to run glass. Applying pressure from the inside or tapping the scrib with glass pliers will run the scribe. I do it easily multiple times a day LOL but yet I cant tell you how to do it perfectly and its never a for sure thing...
|
|
#5
09-13-2011, 11:37 PM
|
||||
|
||||
|
Ill be coming in on the 24th for my Bday party and the frag swap so if you wait I could prob help you out
|
Hybrid Mode
