west 7 epoxy vs cheap all purpes fiberglass resin

randallino · #1 09-08-2011, 02:59 AM

Smallfry this is a good place to start looking for epoxy's coatings etc, they do carry West systems.
http://www.fibertek.ca/index.htm

mike31154 · #2 09-08-2011, 04:22 AM

Like Small Fry I know little about plywood tanks but have also built a cedar strip canoe using fiberglass & West System Epoxy. Yep, the West stuff is expensive, but apparently hard to beat. I haven't tried any other brand (just built the one boat so far), but everything I read prior to and during the build steered me towards the West brand.

As far as strength & layering, I can say from experience that my boat is extremely strong & light as well. With cedar strip/fiberglass/epoxy builds, it's actually the fiberglass that adds strength, so I'd guess that if you want to beef up the strength, get some fibreglass cloth & put the epoxy over that in a few layers, same as boat building technique. It comes in different strengths/thickness & is not that costly when compared to the epoxy. After completing the shell of cedar strips, the hull was quite flimsy & flexible. Once the glass & epoxy went on, it became a very rigid, monocoque type structure. Thwart, seats all contribute to additional strength. A few coats of marine varnish finish the job & protect the epoxy from the sun's UV rays.

Sorry, getting a little carried away with the boat stuff here, but hopefully the info will help you out with your research.

randallino · #3 09-08-2011, 05:03 AM

Nice canoe Mike!

mike31154 · #4 09-08-2011, 02:19 PM

Thank you, it took all summer of '05 to build. Wood came from a small outfit in North Van. IIRC he had the epoxy as well. I had Bob's Special out on Kalamalka Lake yesterday afternoon for a paddle. I'd probably do ok building a plywood tank for a sump, but I have a couple glass tanks kicking around for that purpose already.