|
|
|
|
|
#1
05-07-2011, 04:17 PM
|
||||
|
||||
Spurring new sps growth
I don't know if anyone else has tried this, but a little while ago after trimming a sps branch of a "Green slimer" acro I noticed that quickly 2 new branches started from the spot. So I wondered if I trimmed just 1 coralite what would happen, well now I've got a new branch growing from apart of the branch where there were no signs of new growth previously. I thought this was pretty cool & will try it on other corals to try & inspire new growth.
So I now wonder if there were 2 corals about to touch each other if you were to trim coralites off a lower section of the branch, if the branch would stop shy because it would be dedicating growth energy to the trimmed coralites instead of the end of the branch. Does anyone know anymore about this? 
|
|
#3
05-08-2011, 02:26 PM
|
|||||
|
|||||
|
When ever I get a dormant frag or colony branch (you can usually tell by rounded appearance)....I trim the very tip and new growth is likely to come. Been doing this for quite some time and works really well. Many people do the same thing.
|
|
#4
05-08-2011, 04:45 PM
|
|||||
|
|||||
|
Take a read on the GARF site they say the same thing.
If you break off a breanch opposed to a clean cut most time you will get 2 or more new branches form. This will make for a bushier coral.
__________________
Ryan
|
|
#5
05-08-2011, 06:46 PM
|
||||
|
||||
|
Corals for many years in the old days were thought to be related to plants, and with just cause. Sometimes I have a hard time believing they're animals when I see so many similarities with plants. I do also find a lot of my gardening techniques apply in my tank as well.
I do break off branches and tips to start new growths and to keep the colony in a healthy shape (important for birdsnest and pocci's). Now, trimming a single coralite and getting a new branch? That's cool! Did you just trim a radial coralite? If so, how did you do this? To answer your question, I don't necessarily think forming branches down low will stunt the growth of the main branch. It may slow the growth for a short time as energy is diverted toward growing new branches but I think that will be short lived, especially once the new branch comes "online" and becomes a producer for the colony. Now, if you regulary pruned the colony to form new branches this technique might work. Only one way to find out, right?
|
|
#6
05-08-2011, 09:33 PM
|
|||||
|
|||||
|
Yes, this works and I do it all the time. As mentioned, you want to snap the branch, rather than crush it off with cutters
__________________
400 gal reef. Established April, 2007. 3 Sequence Dart, RM12-4 skimmer, 2 x OM4Ways, Yellow Tang, Maroon Clown (pair), Blonde Naso Tang, Vlamingi Tang, Foxface Rabbit, Unicorn Tang, 2 Pakistani Butterflies and a few coral gobies My Tank: http://www.canreef.com/vbulletin/showthread.php?t=28436 Last edited by untamed; 05-09-2011 at 03:43 AM.
|
Hybrid Mode
