|
|
|
|
|
#1
03-24-2011, 09:37 PM
|
|||||
|
|||||
I personally don't use any rods and glue.
I look at it as your most expensive lego setup. You try to interlock things and make it solid. In some cases where there is a little wobbliness, then I use a bit of epoxy glue. That is it. I guess it depends what you want to do, I have seen some outragous aquascapes. The only way they would work is if rods, glue, ties, etc were used. And have fun with it!!!
__________________
 Setup: 180G DT, 105G Refuge (approx. 300lbs LR, 150lbs Aragonite) Hardware: Super Reef Octopus SSS-3000, Tunze ATO, Mag 18 return, 2x MP40W, 2X Koralia 4's Wavemaker Lighting: 5ft Hamilton Belize Sun (2x250W MH, 2X80W T5HO) Type of Aquarium: mixed reef (SPS & LPS) with fish Dosing: Mg, Ca, Alk Last edited by globaldesigns; 03-24-2011 at 11:03 PM. 
|
|
#2
03-24-2011, 10:26 PM
|
|||||
|
|||||
|
Drilling the rock isn't difficult, but it is very messy. Wear goggles, old clothes and do it outside if possible. Use a masonry bit and go slow. Too fast and the goo flies everywhere. Drilling too big a hole at once may break your rock apart, so if you need a large hole, step up in drill bit sizes. Have fun!
__________________
225g reef
|
|
#4
03-24-2011, 11:04 PM
|
|||||
|
|||||
|
Quote:
__________________
Setup: 180G DT, 105G Refuge (approx. 300lbs LR, 150lbs Aragonite) Hardware: Super Reef Octopus SSS-3000, Tunze ATO, Mag 18 return, 2x MP40W, 2X Koralia 4's Wavemaker Lighting: 5ft Hamilton Belize Sun (2x250W MH, 2X80W T5HO) Type of Aquarium: mixed reef (SPS & LPS) with fish Dosing: Mg, Ca, Alk
|
|
#5
03-24-2011, 11:20 PM
|
||||
|
||||
|
wayne buddy.... heres some alternatives to drilling holes
 super glue duct tape elastic bands velcro pl premium chewing gum needle and thread these are what every one else does lol cheers budddddddyyy!!!!!
__________________
........
|
Hybrid Mode
