dripping pvc

Navarchus · #1 03-23-2011, 03:12 AM

just dry it amd apply pvc glue on it

trilinearmipmap · #2 03-23-2011, 03:23 AM

PVC is so cheap I would just buy new PVC and re-do the plumbing. There is too much to lose to worry about saving a few dollars.

cathyg_99 · #3 03-23-2011, 03:49 AM

Quote:

Originally Posted by trilinearmipmap

PVC is so cheap I would just buy new PVC and re-do the plumbing. There is too much to lose to worry about saving a few dollars.

Ya the PVC is but the ball gate and spring valve isn't so I would have to reorder them from Australia all for a tiny drip an hour from one elbow

The Codfather · #4 03-23-2011, 03:55 AM

Quote:

Originally Posted by trilinearmipmap

PVC is so cheap I would just buy new PVC and re-do the plumbing. There is too much to lose to worry about saving a few dollars.

+1, cut out the elbow and use a couple of couplings/unions. Is it accessible? You could always cut and chip out the fitting.

cathyg_99 · #5 03-23-2011, 04:00 AM

Quote:

Originally Posted by The Codfather

+1, cut out the elbow and use a couple of couplings/unions. Is it accessible? You could always cut and chip out the fitting.

Yes and no it's a 45 in the middle of other 45s to make it a smoother curve I could do it but it's going to be such a b*^%# I'm going to add some glue and see if not it's gotta come out