|
|
|
#13
03-22-2011, 03:48 PM
|
|||||
|
|||||
for a power supply you don't want to go by watts. while this can work it is much easier and safer to go with a constant curent output. so figure out what current you want to run at (700mA or 1000mA) then get one that has enough voltage to handle the amount of LEDs. you want to run your blues on a different power than your whites
here is an example of one of the better drivers to come out laitly http://www.nanotuners.com/product_in...roducts_id=754 this is a 64 top 114 volt driver at 1050mA you can get them bigger or smaller. Steve
__________________
 *everything said above is just my opinion, and may or may not reflect the views of this BBS, its Operators, and its Members. If cornered on any “opinion” I post I will totally deny having ever said this in a Court of Law…Unless I am the right one*Some strive to be perfect.... I just strive. 
|
Threaded Mode
