pH range question for those who have a controller

[The Grizz]

Originally Posted by globaldesigns

Hey Greg, I have been battling the thought of a controller. Do you like yours?

If so, can you use them with a dosing pump. I am looking at automating the vodka dosing, MG, St, Ca and ALK.

Hey Rick, so far I love it I still want to get a Redox & Salinity probe as well as a GHL 4 pump dosing unit. With the Profilux you can get 2,3&4 pump units either stand alone units or controller units.

[abcha0s]

Originally Posted by The Grizz

Hey Rick, so far I love it I still want to get a Redox & Salinity probe as well as a GHL 4 pump dosing unit. With the Profilux you can get 2,3&4 pump units either stand alone units or controller units.

IMO - The Redox and Salinity probes are definitely fun toys to have, but i don't pay much attention to these numbers anymore. They tend to be highly sensative and wander all over the place. Even the smallest stray voltage will send these probes way out of whack. I personally love playing with reef toys, but unless your running ozone on your tank, these probes really are just that.

I guess I'm really just suggesting that your money might be better spent on something else.

[untamed]

Originally Posted by abcha0s

IMO - The Redox and Salinity probes are definitely fun toys to have, but i don't pay much attention to these numbers anymore. They tend to be highly sensative and wander all over the place. Even the smallest stray voltage will send these probes way out of whack. I personally love playing with reef toys, but unless your running ozone on your tank, these probes really are just that.

I guess I'm really just suggesting that your money might be better spent on something else.

I find that the ORP isn't very responsive to ozone, either.

[The Grizz]

Originally Posted by cale262

Mine bounces up and down, Usually peaks around 17:30ish (8.3) and lowest at 02:30 (8.1)....outside temps also affects this, I have an HRV with an exhaust vent directly behind the tank, if the furnace runs more in the day my PH is lower, When it's warmer outside the PH is slightly higher...If I turn off the skimmer for any amount of time while dosing (4hrs etc) the PH drops right down to 8ish. If I have people over and they are in the same room as the tank, I can see the PH drop, then raise after people leave...think this is atributed to Co2 levels in the room etc...Fun to look at the graphs and compair to what was actually going on in the room at the peaks and lows.

That is kind of what I was thinking as well.