|
|
|
|
|
#1
01-21-2011, 05:32 AM
|
||||
|
||||
I think gate valves are the way to go, but I wondered if the components are brass ... this might conflict with saltwater no? I also heard rumor that to some that any 90 degree angle adds to slowing down the, er... it just slows the water movement. I wouldn't want to add strain to the pipe circulation situation, ultimately lining me up with joint weakness and maybe eventually a pop off. ...
|
|
#2
01-21-2011, 05:38 AM
|
|||||
|
|||||
|
We'll never deal with any pressures that make that a risk. That is good advice about not bumping the plumbing. An unmolested bulkhead is a happy bulkhead.
The PVC gate valves with the big wheel you turn...all plastic so no worries. They're just silly expensive. I'd make the second 1.5" hole an emergency drain in case the first gets plugged. Then you can do a herbie setup. I'd just run my return up and over the top no need to tie up that precious hole when you only have 2.
|
Hybrid Mode
