MitchM tank build

[Red Coral Aquariums]

Originally Posted by MitchM

Hi Kevin,

The holes in the top are 2 1/4", the holes in the back are 2 1/2".

That's a good point about the heaters. I wonder how much heat the tank would lose? I heard that acrylic had some insulating properties, plus I'll also be using lids on the tank.
I'm not too concerned about the temporary loss of filtering at this point. I don't want a heavily stocked tank. The tank feedings could occur near the end of the rest cycle.

If I went with your last setup suggestion, I would still need to drill a couple of holes for the sump return, wouldn't I?

As stated before the reeflo dart golds are great pumps (from customer and my personal viewpoint) but I have never had any experience with starting and stopping them on a daily or hourly basis (really not recommended) . I would though recommend your return from your sump to be a constant. You should not need any more holes drilled to accomplish your required tasks. Mitch it looks like you have some options on your 5/1/5 flow pattern which is great.

Kevin

[mr.wilson]

The Profilux can control a wide variety of pumps including the Abyzz. The Abyzz controller has pump temp, RPM, water sensor, and wattage draw which you can't get with aquarium controllers. Whether you need these features or not is another matter

Make sure if you have a variable water level in your sump that your skimmer isn't adversely affected. You can have it shut off on the same timer, if you go that route.

[lastlight]

Originally Posted by mr.wilson

The Profilux can control a wide variety of pumps including the Abyzz.

Oh I didn't know that. So you can buy these pumps without controllers. Also nice to know.

[mr.wilson]

Originally Posted by lastlight

Oh I didn't know that. So you can buy these pumps without controllers. Also nice to know.

The pump comes with a power supply with alarms for power or water shortage. There is a rheostat to manually set the pump output/RPM.

The cool thing about brushless DC pumps is they use less energy at lower RPMs. When you turn the 420 watt pump down to 65% capacity, it only uses 94 watts. A cycle of 35% for 10 seconds and a pulse of 65% for 2 seconds uses much less energy and gives the same net flow (without waves).

I tested a DC pump out of The Netherlands recently. It;s half the price and almost half the electricity, but the magnet on the pump stated to show rust pitting after three months use.

There are a few companies working on brushless DC pumps. Wait 6-12 months and you will see them replacing Iwaki and Sequence etc. For now, the price puts them out of reach for most.