|
|
|
|
|
#1
10-30-2010, 11:59 PM
|
|||||
|
|||||
The previous owner used this stand without any problems. Once you install stiffeners the only place that stand will go is through the floor.
 
|
|
#2
10-31-2010, 03:42 AM
|
|||||
|
|||||
|
Quote:
Jason... we had this talk.... my floor is going nowhere ha ha!!! I hope ha ha!
__________________
 My 70 Gallon build: http://www.canreef.com/vbulletin/showthread.php?t=66478 My Mandarin Paradise: http://www.canreef.com/vbulletin/showthread.php?t=72762 I wonder... does anyone care enough to read signatures if you make them really small? I would not. I would probably moan and complain, read three words and swear once or twice. But since you made it this far, please rate my builds.
|
|
#3
10-31-2010, 05:46 AM
|
|||||
|
|||||
|
1" of weld is only as good as the weld it self, if there is so much as a hair line crack to would not take much to rip. I would think about bracing the tank with maybe a temp 4x4 bridge just to hold the weight before drilling the holes in the frame. But who really know what might happen. I always air on the side of caution.
__________________
Feed the bear goodies, make a new friend, don't feed the bear............... 8' - 165gal Reef DIY LED's Build 2012 Nano Contest Winner Febuary 2013 POTM Winner 300 gal + 60 gal Complete DIY Build
|
Hybrid Mode
