Reinforcing a tank stand?

paddyob · #1 10-30-2010, 06:46 PM

I have a stand that came with my tank. And although I have been told that it will support the tank..... it seems to be "wobbly".

Is there anyway to reinforce a tank stand (metal) without taking the system apart?

If anyone has done this and can provide some insight, I would appreciate it.

Patrick

Wayne · #2 10-30-2010, 07:15 PM

Yeah you just need someone to fabricate some extra support and then drill and bolt them to your stand. Any metal workers out there?

hillegom · #3 10-30-2010, 07:33 PM

Adding 45 degree braces in all corners would be a start. Without knowing what your dimensions of stand and materials used, a definitive answer is difficult. I am sure there would be some knowledgeable metal workers able to answer.

paddyob · #4 10-30-2010, 07:36 PM

Actually I am a structural steel fitter/fabricator.....

But I guess I am concerned about drilling a stand with weight on it..... could this not potentially cause a stress point where "flex" could occur... and possibly give under the pressure?

If it is safe to drill holes without taking the stand apart.... this I could do in a heart beat.

paddyob · #5 10-30-2010, 07:37 PM

Quote:

Originally Posted by hillegom

Adding 45 degree braces in all corners would be a start. Without knowing what your dimensions of stand and materials used, a definitive answer is difficult. I am sure there would be some knowledgeable metal workers able to answer.

The stand is made out of 1" HSS (square tubing). 48" long by 19" wide and about 30" tall.

hillegom · #6 10-30-2010, 08:07 PM

I hope that the 4 foot long has a center brace, with only 1" HSS.
I would not have a problem drilling 1/4 in holes, but how are you going to drill the vertical holes with the tank on top.
Could you weld in place, 1/2 inch tacks at a time? Without disruptiing too much gear below the tank?

paddyob · #7 10-30-2010, 08:40 PM

Quote:

Originally Posted by hillegom

I hope that the 4 foot long has a center brace, with only 1" HSS.
I would not have a problem drilling 1/4 in holes, but how are you going to drill the vertical holes with the tank on top.
Could you weld in place, 1/2 inch tacks at a time? Without disruptiing too much gear below the tank?

No center brace. As for holes... I can drill them horizontally and put small bolts through the front and back to hold the braces as I can access both sides easily.

I do not want to weld in the house. And the problem with small HSS is that you can easily melt the thing to pieces in a heart beat and then you have bigger issues altogether. For that I could enlist my father-in-laws help.... but I do not think it is the best option at this point. He also is a steel fitter/welder of many years. He is the one who told me not to worry about the stand that it will hold.... but its the stability I worry about.

Example... when I use my tank magnet to clean... I can actually feel it sway a little with the strength of the magnet.... thats what has me sweating. I know the steel will hold as it looks to be made very well.... actually looks like it was a manufactured stand as it has nice caps on all ends and everything.

Any thoughts?