![]() |
|
#1
|
|||||
|
|||||
![]() Kein, I hope the tank I'm setting up can be 1/2 as sexy as yours is....
__________________
Spontaneously Purchased Scleractinian anonymous |
#2
|
||||
|
||||
![]() You installed the hrv yourself?? Is it worth the cost?
|
#3
|
|||||
|
|||||
![]() Quote:
No, the vendor installed it. Took them 6 hours ![]() |
#4
|
||||
|
||||
![]() It was my understanding that HRV's needed set "intake points" in a house and didn't draw from your cold air returns...is that true? If yes, did you put an intake point near your tank?
__________________
Mark... ![]() 290g Peninsula Display, 425g total volume. Setup Jan 2013. |
#5
|
|||||
|
|||||
![]() To be honest I did not pay too much attention to where it is plumbed. All I know is that it is tied into the furnace and I can see a new exhaustvent that they had to drill outside. No I did not put and intake near the tank.
|
#6
|
|||||
|
|||||
![]() Quote:
Mine has a 2 fan setup inside and 3 filters, 2 normal foam ones for cleaning the air, and the one big one (I think this is the one for condensation of water)
__________________
![]() Setup: 180G DT, 105G Refuge (approx. 300lbs LR, 150lbs Aragonite) Hardware: Super Reef Octopus SSS-3000, Tunze ATO, Mag 18 return, 2x MP40W, 2X Koralia 4's Wavemaker Lighting: 5ft Hamilton Belize Sun (2x250W MH, 2X80W T5HO) Type of Aquarium: mixed reef (SPS & LPS) with fish Dosing: Mg, Ca, Alk |
#7
|
|||||
|
|||||
![]() I've been following this thread for awhile now and I got to say very impressive and informative.
|
#8
|
|||||
|
|||||
![]() Quote:
![]() |