|
|
|
|
|
#1
10-12-2010, 08:47 PM
|
|||||
|
|||||
If it's similar to a Koralia 1, the metal rod has to fit into a small slot in the cap. if its not inserted properly, the power from the motor could be turning it (slightly) or causing issue. I can post pictures of what I mean when I get home.
|
|
#2
10-12-2010, 09:38 PM
|
|||||
|
|||||
|
Quote:
__________________
 Setup: 180G DT, 105G Refuge (approx. 300lbs LR, 150lbs Aragonite) Hardware: Super Reef Octopus SSS-3000, Tunze ATO, Mag 18 return, 2x MP40W, 2X Koralia 4's Wavemaker Lighting: 5ft Hamilton Belize Sun (2x250W MH, 2X80W T5HO) Type of Aquarium: mixed reef (SPS & LPS) with fish Dosing: Mg, Ca, Alk
|
|
#3
10-12-2010, 10:22 PM
|
|||||
|
|||||
|
The metal rod is part of the cap. I've pulled it apart 6 times figuring I didn't have it on right but it is -hence the confusion.
__________________
-Mark 29 Gal Bowfront w/24" LED Lights. DIY HOB Sump (5.4 Gal) MP40. Orange Spotted Watchman Goby, 2 Clownfish and a few hermits.
|
|
#5
10-13-2010, 04:22 AM
|
|||||
|
|||||
|
No washers in these.
I plugged it in and it's been running about 20 mins now. I'm hoping it'll settle down after a bit.
__________________
-Mark 29 Gal Bowfront w/24" LED Lights. DIY HOB Sump (5.4 Gal) MP40. Orange Spotted Watchman Goby, 2 Clownfish and a few hermits.
|
|
#6
10-13-2010, 05:47 AM
|
|||||
|
|||||
|
i am not sure of your problem, but while its running under water, try sticking a tooth pick or what ever will fit by the impeller and give it a flick, turn, it might start up. It worked for me in the past.
|
|
#7
10-13-2010, 06:21 PM
|
||||
|
||||
|
My koralia has a small grey plastic washer that fits onto to bottom of the magnet. I almost lost it once.
|
Hybrid Mode
