|
|
|
|
|
#1
10-05-2010, 12:24 AM
|
|||||
|
|||||
Check out Reef central they got step by step on building them even the drivers. I was going to put one together but i am a well kind lazy
__________________
360 gallon sps reef, 180 gal sump, bubble king supermarine 300, 4xmp40Wes, 2 x 6215 tunze waveboxes, 4 ghl mitras 360 Reef Tank 
|
|
#2
10-05-2010, 12:26 AM
|
|||||
|
|||||
|
__________________
360 gallon sps reef, 180 gal sump, bubble king supermarine 300, 4xmp40Wes, 2 x 6215 tunze waveboxes, 4 ghl mitras 360 Reef Tank
|
|
#3
10-05-2010, 12:48 AM
|
||||
|
||||
|
I would go 2 blues for every white.
Cree 3W LED's are the most popular. http://ledsupply.com/creexpg-w139.php They come on an aluminium disk, its about 3/4" diameter. Don't make a single strip, make an array. I would buy dimmable drivers, its just so much easier and they are cheap all things considered. Optics... try some of all and figure out what works best, makes it easier to give a smaller spot more light if you have a demanding coral. No reflectors, they focus down on there own. use a heatsink, fans depend on how many LEDs you have and the size/efficiency of your heatsink. you can use an epoxy or you can screw the LEDs down. I would drill and tap holes and use machine screws to hole them down. 18g is plenty fine for wire. I am building a small array of just whites and using T5 for the blues, actinic and fiji purple kind of tubes. Waiting on the XPG to come in blue.
|
|
#4
10-05-2010, 12:58 AM
|
|||||
|
|||||
|
wow thanks Jeff
__________________
180 starfire front, LPS, millipora Doesn't matter how much you have been reading until you take the plunge. You don't know as much as you think.
|
|
#5
10-05-2010, 01:01 AM
|
|||||
|
|||||
|
would i want optics that like the 120 degree more of a spread
__________________
180 starfire front, LPS, millipora Doesn't matter how much you have been reading until you take the plunge. You don't know as much as you think.
|
|
#6
10-05-2010, 02:33 AM
|
||||
|
||||
|
good luck
Make sure you use heat sink epoxy, tape or white paste. Also make sure the LEDS are sealed of from the water. There are 3 things that are most important #1 is heat management #2 heat management and most important is #3 heat management. My company builds LED units for commercial sites. Make sure the LEDS are current and the heat sink calculations are in tune with your LEDS, Good Luck
|
|
#7
10-05-2010, 03:05 AM
|
||||
|
||||
|
Quote:
I'll have 84 over my 48"x18" 90 gallon.
|
|
#8
10-05-2010, 03:07 AM
|
|||||
|
|||||
|
what did it cost to build yours jeff
__________________
180 starfire front, LPS, millipora Doesn't matter how much you have been reading until you take the plunge. You don't know as much as you think.
|
Hybrid Mode
