|
|
|
|
|
#1
09-07-2010, 05:31 PM
|
||||
|
||||
Good luck with everything, I can not imagine what it's like to have a tank crack like that.. I'll bet it's the tank and that all the glass pieces are not square on all sides. I would take it apart and check every part just out of curiosity and if it is the bottom pane of glass have it cut narrower or get a new piece that is narrower and get a new front pane. some times when they cut thick panes of glass the end will run in ward and that is what I suspect happened to that tank the last little piece ran toward the center and is not that noticeable and was missed at the manufacturers. If I were there I would get it off you as I would like a 6 foot tank that is what my stand is built for anyways. I over build things my self..
Anyways good luck. Bill 
|
|
#5
09-08-2010, 12:12 AM
|
|||||
|
|||||
|
Oh no!! I would be suspecting the stand. It sounds like the tank is twisting in order to produce that corner to corner crack. I wouldn't put another tank on that stand.
|
|
#7
09-08-2010, 12:38 AM
|
||||
|
||||
|
I don't think it's the stand....... I think it's the tank.
He got the tank for free because the previous owner had the front panel crack on him. He replaced it with a new panel of Starphire glass and put it on a new very highly engineered stand and it cracked in the exact same way and area. Like Anthony said....... no need to risk it a 3rd time. Time for this tank to become a reptile tank. Cheers, Vic
|
Hope you get it all worked out soon.
Hybrid Mode
