|
|
|
#11
09-06-2010, 06:57 PM
|
|||||
|
|||||
I don't have the lights anymore to check but I believe I used 1/8 inch acrylic on my 4 foot 8 bulb unit. I also used 4 stand offs per side (8 total), not just at the corners, so it was supported in the middle too. The stand offs are threaded for screws at both ends. I took out the bulbs and reflector, drilled small holes in the metal housing and used screws to attach the stand offs to edge of the unit. Then I put the acrylic on the stand offs and marked where holes should go, drilled the acrylic carefully and then used small screws to attach the acrylic to the stand offs.
|
|
#12
09-06-2010, 10:45 PM
|
|||||
|
|||||
|
Does the acrylic slide between the bottom of the stand off and head of the bottom screw?
thanks for the tip
__________________
Clintos:29G Cube 24"x24"x12"D,ATI 24" 6 x 24W powermodule,4 blue,2 x 10 000K ATI's, tap water, 1 mp 10, 1 nano hydor,mag 3 lift pump, approx 40lbs L.R,2" dsb,15G sump/refuge, 23watt refuge light,3" dsb,carbon reactor,filter sock,blastos,yumas,maxi mini carpet's,paly's,perc,algae blenny. "Corals,corals,corals-they are as fascinating as candle lights." PHYTO4LIFE Last edited by phyto4life; 09-06-2010 at 10:59 PM.
|
Linear Mode
