![]() |
|
#1
|
|||||
|
|||||
![]() You could also add your new rock to your old tank and let it run there for a little bit to help it cure. Have you thought about perhaps slowly transfering everthing from 1 tank to another over a period of several week's if possible? Say something like moving 1 rock and 2 fish per week to the new system?
__________________
![]() |
#2
|
|||||
|
|||||
![]() Quote:
__________________
Christy's Reef Blog My 180 Build Every electronic component is shipped with smoke stored deep inside.... only a real genius can find a way to set it free. |
#3
|
|||||
|
|||||
![]() I agree with Christy. I'd transfer some of the old water over.
Good luck with the move. ![]()
__________________
225g reef |
#4
|
|||||
|
|||||
![]() Thanks guys.
The new rock (if it's like the rock I started this tank with) hopefully won't cycle. As odd as it was my rock from Red Coral didn't cycle...at least not according to Elos. The old tank will be shut down so I'd prefer to move it all over at once. What's everyone's motive for using some of the old water? I'll ensure the basic 3 match in both tanks. Is the concern ph? Shock from things we don't measure being different in the new water? Or does old water hold magical powers? ![]() |
#5
|
|||||
|
|||||
![]() here is my way, get wasted the night before. Why? cause your so hung over the next day that your mind works on a routine and worrying does not comply in your head. Than after the move drink again. By the time everything is settled the next day and your cured of your hang over at dinner time everything will be fine and nothing to worry about.
Sounds like you have everything under control. best of luck dude |
#6
|
|||||
|
|||||
![]() Over the years i've done alot of tank transfers and have always used the same water with no problems. Most of them were to a larger system so I just thought of it as a bit of a water change since I was adding new water anyways. I know it does'nt make any sense but it saves on salt. I just did a bigger water change after a week of the tank setup. Have never lost anything in the process.
|
#7
|
|||||
|
|||||
![]() Quote:
__________________
Christy's Reef Blog My 180 Build Every electronic component is shipped with smoke stored deep inside.... only a real genius can find a way to set it free. |
#8
|
|||||
|
|||||
![]() To test the new system and be able to bring the sump etc all online I had to of course mix up saltwater to fill the entire thing. So waste isn't really a concern I guess as I had to fill the thing anyhow. Question is do I bring the system params inline and add my livestock or do that THEN siphon 30 gallons out (new fresh water) and add 30 from the old tank (which has now gone 2 weeks without a waterchange because I've been busy with all this).
I'm also considering buying however much rock I want to add, adding it and letting it cycle in the new setup for however long that may take. Could be really fast or your standard few weeks. Then add the livestock... |
#9
|
|||||
|
|||||
![]() Quote:
If you're going to add new live rock, I'd let it cycle first before livestock. If not, fill the new tank to aprox 30 gals less than full. Siphon most of the water out of the old tank into the new before you move your livestock. This will make catching the fish easier. Harder for them to elude you and hide with little water and rock in the tank. After the livestock is in top up the new tank with the leftover old water. Good Luck!
__________________
225g reef |
#10
|
|||||
|
|||||
![]() So Lance you're suggesting tossing out 30 gallons or so of my new water? System is 100% full and circulating right now.
What I could do is do waterchanges for a few weeks using water from the new tank lol. Dump the old water into the new tank. And yeah think I'll grab all my new rock and let it cycle. I never had a cycle last time and maybe I'll get lucky again. |