|
|
|
|
|
#2
07-06-2010, 04:27 PM
|
|||||
|
|||||
I/we actually had the gentleman who fabricates metal stands for us at Red Coral custom build a bracket that used the existing screw holes to join the two units together.....the brackets I have were a prototype and the light still sags a little in the middle.....I have a small piece of bamboo propping it up against the center brace on my tank(still better that the large tek mounting legs)the brackets needed to be a titch longer.....you could PM Red Coral and see what it might cost to have a set done for you and shipped out....
__________________
260g mixed reef, 105g sump, water blaster 7000 return, Bubble King SM 300 skimmer, Aqua Controller Jr, 4 radions, 3 Tunze 6055s,1 tunze 6065, 2 Vortech MP40s, Vortech MP20, Tunze ATO, GHL SA2 doser, 2 TLF reactors (1 carbon, 1 rowa). http://www.canreef.com/vbulletin/showthread.php?t=50034 . Tank Video here http://www.vimeo.com/2304609 and here http://www.vimeo.com/16591694 
|
|
#3
07-12-2010, 04:52 AM
|
||||
|
||||
|
I managed to attach the two ends together using these little double washers that I found and the 6 screws at the end of each fixture. No sag at all.
I will post a pic later. Thanks to those that replied and helped me figure this out.
|
Hybrid Mode
