![]() |
|
#1
|
||||
|
||||
![]() FYI, current codes require the floor of a residential building to support 40psf live/ and 10-15psf dead load.
In most cases you will be ok with a 120gal on a modern house. Running the tank accross more joists is always better. |
#2
|
||||
|
||||
![]() I guess it sounds like it is good to go.
Again though, does anyone know how to tell where the floor joists are??? |
#3
|
|||||
|
|||||
![]() Here's a thread I found when planning my aquarium. It spells everthing out pretty thouroughly.
http://www.african-cichlid.com/Structure.htm PS: Even though you can calculate the weight of an aquarium filled with water, don't forget all of the rock you will be putting into it, the stand, the sump, surrounding furniture,... every once in a while people passing by, taking a look...(maybe a few when you're having a party)... Alot more to consider than just the aquarium itself. Irregardless, most homes are built to the above MINIMUM standards. However, if you are planning on an aquarium which exceeds the minimum standards, then please refer to your household insurance for guidance. ;-) Riggs.
__________________
Just Love to Build! |
#4
|
|||||
|
|||||
![]() Sorry don't know much about home construction. I have a 144G on hardwood over an unfinished basement with no problems. I would think you'll be ok.
|
#5
|
|||||
|
|||||
![]() As far as finding the direction of the floor joists in the area you want the tank try this......Go to the closest floor heating/AC register, take the grill/insert out and look to see which direction the duct comes from.......if it either runs left or right that is the direction your floor joists will be running parallel with the wall, if the duct runs back towards the middle of the room the joist will be perpidicular to the wall.
May not be 100% full proof but close. |