|
|
|
|
|
#1
05-09-2010, 05:54 PM
|
|||||
|
|||||
My tank is open-top with a powerhead aimed at the surface so I think my oxygen would be ok. My concern is a buildup of this mulm when my skimmer doesn't remove large volumes. I'm thinking the water will get cloudy and the mulm may possibly have other effects if left in the water.
|
|
#2
05-09-2010, 07:38 PM
|
||||
|
||||
|
From what I have noticed in my tank is that there really is no noticeable discharge from the reactor itself. Maybe there is a little bit more particulate in the water column but definitely no clouding. Also the mulm is taken up by fish corals and other critters as afood source. I see my fish eating alot of stuff from the water lately. Also my skimmer is kinda small for the size of tank I run as well.
|
|
#3
05-09-2010, 08:42 PM
|
|||||
|
|||||
|
I just setup my vertex uf-15 reactor and have it Tee'd off of my return pump with the oulet feeding into my skimmer conpartment and getting lots of flow thru the reactor but no tumble
 I added a 500ml bag to the 300ml I already had in my TLF reactor. Do I have to many pellets? should I remove some and throw them out?
__________________
60" 120G project-DONE!!!!
|
|
#4
05-20-2010, 03:21 PM
|
||||
|
||||
|
Alright I have 2 Questions in regards to the Bio pellets sump location and how much should go into the reactor.
1) Where is the best spot to put this in my sump? This is my current sump(attached). I have my Skimmer in the middle compartment and my return in the right compartment. 2) I bought Ian's NpX-Bio Bead / Vertex Reactor kit with mod, UF-15 model with a mj 1200 pump.. From what I have read from the posts, I take out the two sponges, add the pellets, then start it up. How many pellets should I add? Am I missing anything? One last thing...the MJ1200 comes with a bunch of accesories. Does anybody have a pic of one of these set-up? Thanks! Chris Last edited by burblecut; 05-20-2010 at 03:23 PM.
|
|
#5
05-20-2010, 05:34 PM
|
||||
|
||||
|
Quote:
Nice looking sump Chris! Yes, toss the sponges and add 1/2 of the Bio Beads to your reactor, you do not need to use any of the accessories from the MJ1200 box. After about 1-2 weeks add the rest of the Beads and make sure they are tumbling aggressively~ That's it! Ian
|
|
#7
05-20-2010, 06:53 PM
|
||||
|
||||
|
Quote:
Yeah half the bag should be fine although you could most likely start with the whole bag, just watch for clouding if your nutrients are high. Employing the pump in the same compartment would work fine, it makes no difference really. Thanks!
|
Hybrid Mode
