|
|
|
|
|
#1
05-08-2010, 06:48 PM
|
|||||
|
|||||
This is what i do with the PO4 Checker that makes life a little easier at least for me. This method utilizes both vials provided in the kit.
*vial #1 = SW only *vial #2 = SW + reagents mix vial #2 outside of the checker before turning it on and time it for 3 minutes. when the timer gets to about 45 seconds left do the following: 1. Press button to turn on checker 2. wait for C1, insert vial #1 3. press button (wait for it to calibrate) 4. C2 is displayed (wait until vial #2 is done its 3minutes outside before putting it in) 5. once vial #2 is inside press the button 6. it'll give you an instant reading. I found this easier as you can premix everything outside before starting and its just a simple swap of the vials to get your reading. hope that helps.
__________________
Eugene 
|
|
#2
05-08-2010, 10:06 PM
|
|||||
|
|||||
|
Thanks all
Everythign is working now 0.02 J
|
|
#3
07-09-2010, 08:20 PM
|
|||||
|
|||||
|
Hi there,
I just received package with my checker from Oceanic and i did some tests, how can I tell if the checker is actually working properly? I tested water from my tank and reeds - 0.00 (I don't think so, based on problems what I have right now) New mixed water - 0.00 too, water from tap - 0.00. I followed instruction included with checker, i did what OC-Eugen suggested, some results, what i'm doing wrong??? Thanks
|
Hybrid Mode
