Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > Vendor Forums > Aqua Digital

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 04-25-2010, 12:26 PM
Aqua-Digital's Avatar
Aqua-Digital Aqua-Digital is offline
Member
 
Join Date: Jul 2007
Location: Ottawa
Posts: 3,272
Aqua-Digital is on a distinguished road
Default

I would like to now conclude for everyone the balling set up guide, and I think this is the most important part for everyone.

" have all the equipment now what?'

Ok so you have downloaded the manual and have added your salts and trace elements, of course if using the 2.5L containers you just halve all quantities.

Note - it is imperitive if you are following the ballign method to use the Ultra trace B elements as well.

The biggest missconception here is accuracy of the amount of salt to use, the simplest way to explain this worry away is this

Question -I added too much salt OOPS!

Answer - You mix will be stronger so you will find you will require to dose less per dosing cycle.

The opposite of course goes for if you mixed too weak a mixture. So you see no big issue you just adjust your dosing to suit. of course it is advised to try and keep some level of accuracy otherwise everytime you have to make up a fresh batch you would be adjusting your dosing rate to suit.

Initial dosing

Before you dose one single drop make sure you know your levels of Ca,MG,and DKH. Next step is to dose one element and see how that measured amount effects your systems level after 2 hours.

Example - dose 50ml of Ca and then measure who much your calcium rose in two hours from dosing the 50ml amount. if it rose by 50 points you know then 50ml has xx effect on your system.

Repeat this for the DKH and Mg. Once you have reached your target values then it will take about a week for you to dial in exactly what your system draws from the elements. You will find you use 4x the amount of DKH than any othr element this is normal, and also due to the fast take up of FM sodium bicarbonate by your corals do not be surprised if you use even more than this, it is a normal and positive outcome.

Your target values should be

Ca 380-420
Mg 1200-1350
ALK 6.5-8Dkh
Salinity 33-35PPT

A thorough explanation of initial set up is covered in the guide.

Good luck with the system, and you will soon see how great the FM system is and also how amazingly easy the GHL dosers make running such a system
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 03:49 PM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.