|
|
|
|
|
#1
03-16-2010, 01:34 AM
|
||||
|
||||
you can get acrylic scratch kits and yes you can give them a quick polish but be very careful it tends to want to grab allot so go slow and soft. I would go and get a scratch kit there is 2 creams that should come with it 1 for buffing the scratches and the other is for finishing and cleaning. then take some water and rinse it off. should be as good as new.
A buffer works wonder I have seen tanks that have been buffed it is amazing but as I said before you have to be extra careful. Bill 
|
|
#2
03-16-2010, 02:14 AM
|
||||
|
||||
|
thats good to hear bill i have a 300 gal acrylic sitting in the garage collecting dust and i really dont want it to be just a sump
|
|
#3
03-16-2010, 04:21 AM
|
||||
|
||||
|
when buffing take your time and get the kit it helps and takes out the small scratches nicely then buff the others out. Wit will take some time to do the whole tank but you will be pleased and when cleaning you might as well put in new bulkheads while you are at it to make sure the rubber seal is good. Better to do it while it is dry and not full of water.
Bill
|
|
#4
03-16-2010, 10:46 PM
|
|||||
|
|||||
|
Yes....and I'll add that you can continue to polish out scratches on the inside even after the tank is running by using a variety of super-duper fine sandpapers.
__________________
400 gal reef. Established April, 2007. 3 Sequence Dart, RM12-4 skimmer, 2 x OM4Ways, Yellow Tang, Maroon Clown (pair), Blonde Naso Tang, Vlamingi Tang, Foxface Rabbit, Unicorn Tang, 2 Pakistani Butterflies and a few coral gobies My Tank: http://www.canreef.com/vbulletin/showthread.php?t=28436
|
|
#5
03-17-2010, 01:00 AM
|
|||||
|
|||||
|
WOW this is good to know, I have always been told that you can't polish acrylic. Bad info previously received.
__________________
Feed the bear goodies, make a new friend, don't feed the bear............... 8' - 165gal Reef DIY LED's Build 2012 Nano Contest Winner Febuary 2013 POTM Winner 300 gal + 60 gal Complete DIY Build
|
Hybrid Mode
