diy overflow

[Steve_the_nucks_fan]

ok here is another picture to see if i understand what your saying.

[banditpowdercoat]

Can't read anything on the pic, to small, but the sideways T that goes into the 90 that does on the downpipe to the sump. Between the T and the 90, drill a hole on the top of the pipe. 1/8" to start. this is a siphon break. I have never made a overflow like you have there, but I know you need an air inlet. Acctually, looking at that Drill the hole in the cap that you filled the pipe up with.


Try it first Without the cap on the top of the T, I bet it just may work fine without that cap, Fill it up, and then open valve and see

[Steve_the_nucks_fan]

Ok I will try with out the cap and see what happens and then go from there. Thanks so much for all the help.

[banditpowdercoat]

No problem, I know it may sound strange, drilling a hole in somehting that's draining water, but sometimes they drain water TOO well LOL. need some air to slow them down and equalioze things

Let us know how it works. It may be noisy with no cap, so thats why you vary the size of a hole in it, to allow just enough air, but not get that toilet sucking noise

[golf nut]

I suspect you are not priming at all, I don't care how you force water in the bubbles have the capacity to remain in the top of the U, drill and tap and install a john guest fitting in the first u tube, fill as normal then draw the remaining air out of the top of the U then submerse the JG tube below the surface of the water and you should be good to go, the principle on this system is sound.

[Steve_the_nucks_fan]

ok well i tried with out the cap and nothing drained out at all.
and yes i am priming it,im puting the garden hose in the pipe. check out the video i posted. i also moved the t joint down so it was lower than the water intake and that did nothing.
do you think it might be because the pipe isnt glued together? and its drawing in air at each fitting? there are just so many variables unvolved in this lol and ive never made one before so i dont know how to trouble shot the problem..

[golf nut]

Originally Posted by Steve_the_nucks_fan

and yes i am priming it,im puting the garden hose in the pipe. .

Please believe me, this is not priming it, you may think it is but it isn't,

[banditpowdercoat]

Ya Paul, your right, with a vent hole, it may need a fill hole at the "over the tank" section. When he filled it in the video, with no hole, it got a full suction, and because there was no vent to break suction when tank got to level, it continued to siphon untill the inlet got uncovered and broke the siphon that way.

Steve, it may not start with the cap removed like I suggested because there will not be water in the over the tank bend to start with. This needs to be full and no air in it in order to create the siphon from the tank. Then, the air inlet at the T, that makes it so the siphon will stop, when tank reaches that level, but the over the tank pipe remains full of water

I hope I'm not confusing you, I can see it clearly in my head but seeing and describing are 2 different animals LOL

[banditpowdercoat]

OK, With my awesome paint skills, I revised a couple changes.

And ya it won't start without the cap. If you filled it, put cap on, started siphon, let run a little to ensure all air out of the over the tank pipe, then pull cap off I bet it may work.