Grizz's 8' shallow sea

xtreme · #1 02-24-2010, 01:22 AM

I've gotten hole saws from mops.ca before, they work well and are cheap. I thought I might have a 65mm bit your could have but I went and checked and its 75mm.

The Grizz · #2 02-24-2010, 02:22 AM

Quote:

Originally Posted by xtreme

I've gotten hole saws from mops.ca before, they work well and are cheap. I thought I might have a 65mm bit your could have but I went and checked and its 75mm.

Do you think that a 75 mm hole would be to big for a 1 1/2" bulkhead? I could fill in the hole around the bulk head with silicone.

xtreme · #3 02-24-2010, 03:01 AM

If it were me I would get a 2" bulkhead then reduce it to 1.5" outside the tank if that would work for your application.

The Grizz · #4 02-24-2010, 03:14 AM

Quote:

Originally Posted by xtreme

If it were me I would get a 2" bulkhead then reduce it to 1.5" outside the tank if that would work for your application.

I will check to see what I have for bulk head in my stock if I got one that would work. It is for the feed to the pump for my closed loop so going down to 1 1/2" at the pump would not be an issue.

superduperwesman · #5 02-24-2010, 03:27 AM

Very clean plumbing. Looks good. No Herbie?

The Grizz · #6 02-24-2010, 03:35 AM

Quote:

Originally Posted by superduperwesman

Very clean plumbing. Looks good. No Herbie?

No I thought I would try the durso standpipe on this tank. I am not going to glue the bottom of the stand pipe into the bulk head untill I test it to see how it works.

xtreme · #7 02-24-2010, 03:38 AM

Well I do have a 45mm bit as well. If you are in town you can come a grab them both. Only thing is I'd like to have the 45 back since I might need it again. Even if you returned it in the next couple months that would be fine, I won't be using it anytime soon.

The Grizz · #8 02-24-2010, 03:44 AM

Quote:

Originally Posted by xtreme

Well I do have a 45mm bit as well. If you are in town you can come a grab them both. Only thing is I'd like to have the 45 back since I might need it again. Even if you returned it in the next couple months that would be fine, I won't be using it anytime soon.

That would be sweet. I hope to be there for work next week if all goes to plan. Shoot me a pm with your contact info. I will get them drilled and back to you fairly quick.